E-Pen InMotion E-Pen Guía de usuario descargar pdf (Pagina 7)

CHAPTER 2: GETTING STARTED

This chapter describes:

Installing the battery

Installing and Uninstalling the DigiWrite software

Connecting the Receiver to your computer

Attaching the clip to paper

Page position and Writing area

INSTALLING THE BATTERY

The E-Pen cannot transmit a signal until the battery is installed.

Follow these steps to install the battery for the first time:

1. Remove the battery cover by placing a finger on the end of the pen,

applying light pressure and turning the cap counter-clockwise.

2. When you feel the inner clips fit into the grooves on the inside of the

pen; pull the battery cover away from the pen.

3. Insert the battery with the positive sign (+) facing up. See Figure 8,

Chapter 5: E-Pen Maintenance

4. Replace the battery cover by matching the clips in the cover with

the grooves on the inside of the pen and then turn the cover in a

clockwise direction to secure it.

INSTALLING THE SOFTWARE

Before installing the software, make sure that your computer complies

with the following System Requirements:

USB port

Windows 98/ME/2000/NT 4.0 operating system

Pentium

II or higher processor

CD-ROM drive or Internet access

Note: The E-Pen DigiWrite software is provided on CD-ROM. If you do

not have a CD-ROM drive; you can download the files from the E-Pen

website at: www.e-pen.com.

1 2 3 4 5 6 7 8 9 10 11 12 ... 26 27

Sin comentarios

E-Pen InMotion E-Pen Guía de usuario Pagina 7